pH and EC Meter Case

The PH600 and CD611 pH and EC case brings two meters together in a protective carrying case.

This PH600 and CD611 pH and EC case is ideal for hydroponics, aquariums and water treatment, among others.

Includes

• pH 600 meter
• CD611 EC meter
• Calibration screwdrivers
• Calibration solutions

The PH600 meter has

• Scale from 0.0 to 14.0
• Resolution of 0.1
• Manual one-point calibration (with screwdriver),
• 3 x 1.5V batteries.

The CD611 (EC) meter has

• Scale from 0.0 to 20.0 mS
• Resolution 0.1 mS
• Manual one-point calibration (with screwdriver)
• 3 x 1.5V batteries.

pH 600 meter

Operation

• Don't be surprised to see white crystals around the head of the meter. This is normal for a pH electrode. These salts will dissolve in water
• Remove the black cap and switch on the meter
• Immerse up to the limit mark and wait for the reading to stabilise
• After use, rinse the electrode in water to keep it clean.
• Preserve the electrode by putting a few drops of MA9015 storage liquid or pH 7.0 calibration liquid in the cap.
• Always replace the cap after use.
• DO NOT USE distilled or deionised water for storage.
• Large differences in readings (± 0.5 pH) can occur due to the need for calibration, a dry electrode or weak batteries

Calibration

• The calibration procedure is simple and quick
• Immerse up to the limit mark in pH 7.01 calibration liquid (M10007)
• Wait for the reading to stabilise and adjust to pH 7.0 with the screwdriver on the screw at the back.
• The meter is calibrated.
• ALWAYS USE fresh calibration solutions and never reuse them.

CD611 EC meter

Operation

Remove the black cap and switch on the meter with the ON / OFF button located on top.

• Immerse up to the limit mark and wait for the reading to stabilise.
• The meter automatically compensates for temperature variations.
• After use, rinse the electrode in water to keep it clean.
• The value shown on the screen must be multiplied by 100 to give a direct reading in mS/cm.

Calibration

• The calibration procedure is simple and quick
• Immerse the meter up to the limit mark in the EC calibration liquid (M10031)
• Wait for the reading to stabilise and, with the screwdriver on the screw
• Adjust to 1.4 (multiplied by 100 gives an EC of 1413)
• The meter is calibrated.
• ALWAYS USE fresh calibration solutions and never reuse them.

For any questions about your PH600 and CD611 pH and EC case, please contact us. We will be delighted to help you.

We recommend purchasing pH sensor storage solution.